Quindrel
Quindrel
WashForge

WashForge™pressure washer

$179.99

  • 1800W electric motor, 110 bar, 360 l/h
  • Nozzle adjusts from 1° to 180°
  • Brass M22 trigger gun fitting
  • Weighs 5.3 kg with built-in storage hooks

FREE GIFT

Free Gift - Car Detailing Brush Set

FREE
Tracked Shipping
  • Connect a garden hose to the M22 inlet. The built-in filter sits behind it.
  • Plug the 5.5m cord into a covered outdoor outlet.
  • Attach the 7m outlet hose and the lance. The fittings twist-lock, no tools needed.
  • Twist the nozzle on the wand to set the spray pattern, from 1° to 180°.
  • Pull the trigger to spray. The 1800W motor drives the pump while the trigger is held.
  • Release the trigger, then coil the hose and cable onto the storage hooks and put the unit on a shelf.
  • WashForge 1800W electric pressure washer body
  • 7-meter outlet hose with M22 fittings
  • Adjustable 1-180° spray lance and trigger gun
  • 5.5-meter mains power cord with power switch
  • Detergent suction tube for foam-soap pre-wash
  • Built-in water inlet filter (replaceable)
  • Integrated storage hooks for hose and cable

We offer free shipping on orders over $150. Once your order is dispatched, the estimated delivery time is 5 to 12 business days depending on your location — tracking is emailed as soon as it ships.

Changed your mind? You can return your product within 90 days of delivery for a refund — see our Returns page for the full policy.

Flow, Weight, Filter and Nozzle Specs

Flow and Pressure

The washer runs 360 l/h, which is 1.6 GPM, at 110 bar. Pressure drives the rinse, while the flow rate is the figure to check when you pair it with a foam cannon.

5.3 kg Body

The unit weighs 5.3 kg, so you can carry it by hand around a vehicle. It pairs with a 7m outlet hose that you can pull out to reach the far side.

WashForge

Inlet Water Filter

A built-in mesh filter sits at the water inlet and catches grit before it reaches the pump. The filter is replaceable, so you can swap it out when it needs attention.

Adjustable Nozzle

The spray lance twists from a 1° narrow jet to a 180° wide fan. You change the pattern at the wand, so you can move from wheel barrels to body panels.

Frequently Asked Questions

WashForge has an 1800W electric motor and a 5.5m mains cord. Plug it into a covered outdoor outlet and connect a garden hose to the M22 water inlet. It needs no fuel.

It delivers 110 bar at 360 l/h, which is 1.6 GPM. The nozzle on the lance adjusts from a 1° jet to a 180° fan, so you choose the spray pattern for each surface.

Use the included detergent suction tube for a foam-soap pre-wash. The trigger gun also has a brass M22 fitting, so you can attach a standard M22 foam cannon if you own one.

The outlet hose is 7m long and uses M22 fittings. After use, coil it onto the integrated storage hooks on the body. The power cable has hooks too.

The built-in mesh filter sits at the water inlet and catches debris before it reaches the pump. It is replaceable. Check it from time to time and clean or swap it as needed.

The pump runs while you hold the trigger. Pull to spray, release to stop. Releasing the trigger ends the spray, so you can pause between panels without switching the unit off.

The trigger gun has a brass M22 fitting. It takes M22-15mm foam cannons, lances and quick-disconnect couplers. Match the thread size on any accessory before you connect it.

Switch off, release the trigger and drain the hose. Coil the outlet hose and the cord onto the integrated hooks. The unit weighs 5.3 kg and sits on a garage shelf.

WashForge outputs 110 bar, roughly 1600 PSI, with a flow of 360 l/h (1.6 GPM). The adjustable 1-180° nozzle on this electric pressure washer changes the spray from a narrow jet to a wide fan.

The WashForge pressure washer includes the 1800W body, a 7m outlet hose, a 1-180° spray lance with trigger gun, a 5.5m power cord, a detergent suction tube and a replaceable inlet filter.
WashForge

Ready to make it yours?

Get WashForge at today's price with your free gift included — and a full 90 days to enjoy it.

Your free gift: Free Gift - Car Detailing Brush SetFREE
90-Day Money-BackTracked Shipping
Secure Checkout
Tracked Shipping
Customer Support
Loved by our customers

WashForge: An Electric Pressure Washer for Car and Garage Use

WashForge is a pressure washer built around an 1800W motor, made for car washing and general garage cleaning. This electric pressure washer works at 110 bar with a flow of 360 l/h (1.6 GPM), and the body weighs 5.3 kg.

The trigger gun has a brass M22 fitting for foam cannons and lances, and a detergent suction tube is included for foam-soap pre-wash. A thumb-twist 1-180° nozzle on the wand moves from a 1° pencil jet to a wide fan.

As a portable pressure washer, it comes with a 7m outlet hose, a 5.5m mains cord and integrated hooks for hose and cable storage. A replaceable inlet filter sits at the garden hose connection. Used as a power washer for wheels and body panels, the pump runs while the trigger is pulled.

Related guides

Homeowner checking the hose connection on a pressure washer on a drivewayPressure Washing, Snow & Weed ControlPressure Washer Servicing: A DIY Maintenance Checklist8 min read

You may also like

NorthSweep

Electric Snow Shovel

NorthSweep

$279.99

GaleHawk

Handheld Gas Blower

GaleHawk

$229.99

JetPulse Pro

Power Washer For Home Use

JetPulse Pro

$199.99

ScorchWand

Weed Burner

ScorchWand

$169.99

Free gift included