Quindrel

How to Put Windshield Wipers Up for Snow, and When Not To

Lift each wiper arm by its base until it locks upright, but only for snow that will sit on the car. This guide covers storm types, the lift, stuck arms and morning clearing.

Q

The Quindrel Team

November 18, 2026 · 7 min read

Sedan with raised wiper arms showing how to put windshield wipers up for snow overnight

To learn how to put windshield wipers up for snow, grip each arm at its metal base, pull it away from the glass until it stands upright and holds, then leave the blade clear of the windshield. Do it when snow or ice will sit on a parked car overnight, and skip it in high wind or when your arms do not lock upright.

The goal is to keep the rubber off the glass so it cannot freeze to the surface. Below you will find a decision by storm type, the lift step by step, what to do when an arm will not go up, and the morning routine.

Wipers up or down: decide by storm type

Lifting is a choice, not a rule. The right call depends on what is falling, how hard the wind blows and how your arms are built. Use this table the night before.

ConditionsWipersReason
Light, dry snow, calm nightUp or downLittle weight lands on the arms, and blades come off the glass without much resistance.
Heavy, wet snowUp, or cover the glassThe blades stay clear of the glass, but a thick load can weigh on raised arms, so brush them off in the morning.
Freezing rain or iceCover the glass if you canIce can coat the arms and bond the blade to the windshield; a cover keeps the glass clear.
Strong wind forecastDown, or cover with strapsA gust can push a raised arm back onto the glass.
Frost only, no snowUp or downFrost forms on the blades either way; lifting only keeps the rubber off the glass.

If you park under a roof or in a garage, leave the wipers down. Lifting only helps when precipitation will land on the car.

Why lift wipers before snow

Wet rubber that touches cold glass can freeze to it. When you then turn on the wipers, the motor pulls against the ice and the rubber blade can tear or the arm can strain. Standing the arms up leaves a gap, so the blade is free when you return.

Raised arms also let you clear the windshield in one pass instead of working around the blades. That is the whole case for lifting; it does not replace clearing snow and ice before you drive.

How to put windshield wipers up for snow, step by step

Do this with the car off and the wipers parked in their resting position. Check the owner's manual first, since some vehicles use a service position for the wipers.

  1. Park on level ground and turn the wipers off so the arms rest at the base of the windshield.
  2. Brush any loose snow off the area around the arm base so you can see where it pivots.
  3. Hold the arm near the base, where it meets the pivot, not the blade or the thin middle section.
  4. Lift the arm straight away from the glass until it passes upright and holds in place.
  5. Repeat on the second arm. Leave the blades pointed away from the glass, not angled back onto it.
  6. Give each arm a light push to confirm it holds before you walk away.

Lift without stressing the springs

Each arm is loaded by a spring that presses the blade onto the glass. Lift slowly and by the base, because a pull on the blade can bend the frame and a sharp lift can stress the spring tension. Stop when the arm holds; do not force it past its stop.

To lower an arm, support it with your hand all the way down. If you let go early, the spring can snap it onto the windshield and chip or crack the glass.

Gloved hand lifting a wiper arm, showing how to put windshield wipers up for snow before a storm
Lift by the arm base and let it hold upright; do not pull on the blade.

Why your wipers will not go up all the way

If an arm lifts partway and drops, or will not stand upright, check these causes in order.

  • Ice or snow has bonded the blade to the glass. Do not pull; run the defroster until the rubber loosens.
  • The arm is not clearing the hood or cowl. Some arms do not stand upright, and others only lift to an angle that rests against the glass.
  • The spring or the arm's locking joint has worn. The arm swings back as soon as you let go.
  • A bent arm or a loose pivot nut is shifting the hinge.
  • Your vehicle uses concealed wipers that need a service position. Look in the manual for the steps.

If the joint is worn or the arm will not hold, leave it down and cover the windshield instead. Ask a mechanic to replace a worn arm.

When not to put the wipers up

Leave the wipers down in these cases:

  • High wind is forecast, which can slam a raised arm back onto the glass.
  • The arm does not lock upright and drops when released.
  • You park in a garage, carport or under cover.
  • You expect freezing rain that could coat the arms with ice and add weight.
  • You will not be at the car in the morning to lower the arms by hand.

Raised wipers also catch on car washes, garage doors and tight parking structures. In summer sun there is no reason to lift them, and a lifted arm left in warm weather adds nothing.

Cover the glass instead of lifting the arms

A cover on the windshield keeps snow and frost off the glass, so you can leave the arms in place. FrostDrape is a windshield cover for snow and frost. You lay it over the glass and hood the evening before, hold it down with 12 built-in magnets along the hood edge, loop the wind straps at the wheels and fold the ear flaps over the mirrors. Before you drive, you pull it straight off.

It is made of aluminum film, PP cotton and non-woven fabric layered together, with dual-color reflective strips, and it folds into a storage bag for the off-season. For a longer look at covering glass, see how to use a windshield sun shade, which covers fit and which side faces out.

FrostDrapeIn this guideFrostDrape$79.99

Field note

Lay the cover on in the evening and pull it off before you start the car, then lower any raised wiper arms by hand before you turn the wipers on.

Morning clearing steps

Work from the top down so loose snow does not land on glass you have already cleared.

  1. Remove the cover, if you used one, by pulling it straight off. Shake it clear away from the car.
  2. Brush the roof first, then the hood and trunk.
  3. Brush snow off the raised wiper arms and blades, then lower each arm by hand.
  4. Start the car and set the defroster to warm the glass.
  5. Brush the windshield, then scrape any ice with a scraper held at a low angle.
  6. Clear the side windows, mirrors, lights and the plate before driving.

Do not pour hot water on frozen glass, and do not run the wipers across a frozen windshield. If a blade is stuck, let the defroster loosen it.

Tools that fit the job

Do not skip the roof: snow left there can slide onto the glass as you drive. SnowStrider is a car snow brush kit with a brush head, an ice scraper head and a snow shovel head that attach to one telescopic handle. The rod extends from about 17 to nearly 25 inches, and the head locks every 90°, so you can reach across a roof from the ground. The set packs into a carry bag.

SnowStriderIn this guideSnowStrider$59.99
Driver brushing snow from a parked SUV on a winter morning
Clear the roof before the glass so snow does not slide back onto it.

For ice on the glass, ThawJet is a heated windshield scraper that plugs into a car's 12V outlet. You flip the one-touch switch and run the heated edge along the glass where the ice sits, then pull the built-in rubber wiper across to clear the melted water. The 2.7m (about 8.9 feet) cord is long enough to work around an SUV or truck, and the body is stainless steel with reinforced PVC.

ThawJetIn this guideThawJet$39.99

How to prepare your car for a snowstorm

Lifting the wipers is one item on a longer list. Run through it the day before the storm.

ItemWhat to do
Parking spotChoose a spot away from hanging branches and clear of the street plow line.
WipersLift them by the base, or cover the glass; check the blades for cracks.
Washer fluidFill the reservoir with a winter fluid made for cold weather.
Snow toolsKeep a brush, scraper and shovel head in the trunk.
TractionCheck tire tread and keep chains in the trunk if your area needs them.
Fuel and phoneFill the tank and charge your phone and a portable power source.

If you drive where chains are required, read how to put on tire chains for fitting and tensioning. Our Winter & Weather Protection collection lists more cold-weather gear for the car.

If the wiper blades tear, streak or chatter, replace them before the storm. Cracked rubber leaves lines across the glass even when the arms lift without trouble.

Field note

Take a photo of the parked car, wipers included, before you go inside. If the wind picks up overnight, you will know which way the arms were set.

Frequently asked questions

Lift them when snow or ice will sit on a parked car overnight and the wind is calm. Leave them down in a garage, in high wind, or when the arms do not lock upright. A windshield cover is another option that leaves the arms in place.

Hold the metal arm near its base, pull it straight away from the glass until it stands upright and holds, then repeat on the other side. Do not pull on the blade. Lower each arm by hand so the spring does not snap it onto the glass.

Park away from branches, lift the wipers or cover the glass, fill the washer fluid, and keep a snow brush and scraper in the trunk. Check tire tread, carry chains if your area calls for them, and fill the fuel tank.

The blade may be frozen to the glass, the arm may be stopped by the hood or cowl, or the spring or locking joint may be worn. Concealed wipers can need a service position. Check the manual, and ask a mechanic about worn arms.